VEM Line Editing Mode
Which way lines move when one is inserted or deleted.
CSI 7 h
- ECMA-48
- §7.2.19 VEM – Line Editing Mode, p. 25
- DEC STD 070
- §5.10.1.3 Modes That Cannot Be Changed, p. 5-134
Mode 7 decides which lines move when a line is inserted with IL or deleted with DL. DEC STD 070 calls it Vertical Editing Mode.
| State | ECMA-48 calls it | Meaning |
|---|---|---|
Reset, CSI 7 l | FOLLOWING | the active line and those below it move down for an insertion, and up to close a deletion |
Set, CSI 7 h | PRECEDING | the lines above move up for an insertion, and down to close a deletion |
DEC STD 070 §5.10.1.3, p. 5-134 lists it among the X3.64 modes a DEC terminal may treat as fixed, as reset. The VT510 manual’s table of modes for DECRPM marks it as always reset. That is the way IL and DL work in xterm and libghostty-vt.
xterm ignores CSI 7 h and CSI 7 l (ansi_modes handles only modes 2, 4, 12 and 20), and DECRQM reports the mode as permanently reset, 4 (do_ansi_rqm). libghostty-vt ignores it too, but does not recognize the number, so it answers DECRQM with 0. Both DECRQM cases are known differences.
Validation
VEM-1: Reported as permanently reset
\e[7$p
|_____|
reply \e[7;4$y
VEM-2: Even after it is set
\e[7h
\e[7$p
|_____|
reply \e[7;4$y
VEM-3: IL still pushes the lines below down
A\r\n
B\r\n
C
\e[7h # ignored
\e[2;1H
\e[L
|A__|
|___|
|B__|