EBM Editing Boundary Mode
A mode ECMA-48 has removed.
CSI 19 h
- ECMA-48
- §F.5.1 Editing Boundary Mode (EBM), p. 88
- DEC STD 070
- §5.10.1.3 Modes That Cannot Be Changed, p. 5-134
Mode 19 is gone from ECMA-48. The fourth edition deprecated it and the fifth, the one this site follows, removed it; only its number is left, in the table of modes under SM.
| State | ECMA-48 calls it | Meaning |
|---|---|---|
Reset, CSI 19 l | — | removed |
Set, CSI 19 h | — | removed |
DEC STD 070 §5.10.1.3, p. 5-134 lists it among the X3.64 modes a DEC terminal may treat as fixed, as reset. The VT510 manual’s table of modes for DECRPM marks it as always reset.
xterm ignores CSI 19 h and CSI 19 l (ansi_modes handles only modes 2, 4, 12 and 20), and DECRQM reports the mode as permanently reset, 4 (do_ansi_rqm). libghostty-vt ignores it too, but does not recognize the number, so it answers DECRQM with 0. Both DECRQM cases are known differences.
Validation
EBM-1: Reported as permanently reset
\e[19$p
|_____|
reply \e[19;4$y
EBM-2: Even after it is set
\e[19h
\e[19$p
|_____|
reply \e[19;4$y